How Switches Quietly Corrupt EMC Test Measurements and How to Prevent It
An EMC test setup relies on a switch to route a single receiver between antennas or signal paths, yet switches are rarely calibrated properly despite their insertion loss changing with each relay closure. Radiated emissions results depend on a substitution loss that includes switch loss, which drifts with the closed contact, operation count, and ambient temperature, potentially eroding narrow margins against limits. The article recommends calibrating the switch in its assembled, used state for each position, and recording measured insertion loss versus frequency rather than relying on datasheet figures. In high-field immunity testing, the switch housing's shielding effectiveness, along with gasketed metal enclosures and filtered or fibre-optic control interfaces, is critical to prevent fields from bypassing the antenna. Reflective switch states can also create standing waves on unused feeds, so absorptive switches with terminated unused ports are recommended.
This is an AI-generated summary. ShortSingh links to the original source for the complete article.
Discussion (0)
Log in to join the discussion and vote.
Log in